The small print
- Pieces
- 4 cutter and stamp shapes
- Size
- Approx. 83 mm tall, 53 to 69 mm wide
- Cutting depth
- 16 mm
- Emboss depth
- 2.5 mm
- Material
- PLA plastic, 3D printed
- Finish
- Fine layer lines are part of the process and normal on a printed cutter
- Colour
- Filament shades vary between batches and may not match your screen exactly
- Food contact
- Suitable for brief contact with dough. Not for storing food, and not for hot or oily mixtures
- Play dough
- Works on play dough as well as biscuit dough. Wash and dry it before it goes back in the kitchen
- Washing
- Hand wash in warm (not hot) water and dry immediately. Not dishwasher safe
- Heat
- Keep out of the oven and away from hot trays; PLA softens with heat
- Age
- Not a toy. A kitchen tool for ages 3 and up, used with an adult
- Made in
- New Zealand
Gingerbread Family Set of Four
The gingerbread man, and the three relatives who usually get left out.
Colour · Lilac
Every one of these is printed in this colour.
- ✓Posted in 1 to 2 days from Canterbury
- ✓Free NZ Economy shipping over $60
- ✓Works on biscuit dough and play dough, ages 3 and up
- ✓Hand wash in warm water, dry straight away
About this shape
Everybody owns a gingerbread man. Nobody owns the rest of the family, which is why a tray of them always ends up as the same biscuit forty times over. Four different characters here: the plain one with the bow tie, a girl in a ruffled dress, a winking one covered in stars, and one in a santa hat with a candy cane over its shoulder.
The face, the buttons and the icing cuffs are pressed into the dough by the same push that cuts the outline, so a plain gingerbread biscuit comes off the tray already decorated. That is the point of these: you can pipe over the lines later if you want to, but you do not have to. Best on a firm chilled dough. Press straight down and lift without twisting so the candy cane and the hat bobble keep their edges.